The Kenmore dishwasher F2 error code indicates either a door latch fault or that the dishwasher’s leak sensor has detected water in the base pan. This is a protective fault that prevents the dishwasher from operating when a potential leak has been identified, protecting your floors and cabinetry from water damage.
Common Causes of the F2 Error
- Water has accumulated in the bottom base pan, triggering the float switch
- A door latch that is not fully engaging or a misaligned door
- A faulty door latch switch
- A leaking water inlet valve, pump seal, or door gasket
- Overfilling due to a defective float assembly
Troubleshooting Steps
- Pull the dishwasher out slightly and inspect the base pan for standing water.
- If water is present, find the source of the leak before running the dishwasher again.
- Check the door gasket for tears, warping, or debris preventing a full seal.
- Inspect the door latch mechanism for damage or misalignment.
- Reset the dishwasher by unplugging for 5 minutes after mopping up any water in the base pan.
Professional Repair
An F2 error code that persists after checking for visible water and resetting the dishwasher indicates an internal leak or a faulty float switch or door latch component. Our technicians will identify the source of the leak, repair or replace the faulty component using factory-certified parts, and ensure your dishwasher operates safely. Do not continue to use a dishwasher showing an F2 error — water damage can be costly and extensive.